Antonios Kiriazidis

HVAC Work

HVAC, Geothermal, Chimney liners & Oil Tank Permit WILTON

Bathrooms, kitchen, and laundry. No electrical, low-voltage wiring, or gas piping.

HVAC Work

Bathrooms, kitchen, and laundry room.

2 units: install in each 1 goodman, 2 1/2-ton 13 seer r-32 AC unit and 1 goodman 60,000 BTU high efficiency gas furnace. No electrical of gas piping.

First-floor kitchen: install 1 Rheem 95% gas furnace, 60,000 BTU. First-floor living room, bedrooms, and basement apartment: install 1 Rheem 95% gas furnace, 85,000 BTU. Vent kitchen and bathrooms. No electrical or gas piping.

For the second floor and attic: install 1 Goodman 95% gas furnace, 60,000 BTU; no electrical.

For the room above the garage, install 1 Goodman 2 ton 13 SEER R-32 AC unit and 1 Goodman 40,000 BTU 95% high-efficiency gas furnace. No electrical or gas piping.

Install 2 units in each : 1- goodman 2 1/2-ton 13 seer r-32 AC unit and 1- goodman 60,000 BTU high efficiency gas furnance. No electrical or gas piping.

Install: 1- goodman 95% gas furnace 60,000 BTU and 1- goodman 3-ton 14 seer2 AC 454 unit. No electrical or gas piping.

Replace old furnace with 1 Century 92% high-efficiency gas furnace, 80,000 BTU.

First floor and basement: Install 1 Rheem 95% gas furnace, 70,000 BTU, and 1 Rheem 3-ton 14 Seer 2 410A AC unit. Second floor: Install 1 Rheem 95% gas furnace, 70,000 BTU, and 1 Rheem 3.5-ton 14 Seer 2 410A AC unit. Vent the kitchen, bathrooms, and laundry. No electrical or gas piping.

For 2-second floor bedrooms, family and dining room in front of house - install 1 Goodman 2.5-ton AC Unit 1. 3 Seer 410A and 1 Goodman 2.5-ton air handler - no electrical.

Re-route existing supply in mudroom.

For Basement- Erie to remove ice and water Erie to furnish Erie to furnish and flashing. Erie to vent Erie to furnish Erie to furnish ADDITIONAL Install Erie edge. Install Run new zone from existing unit existing roofing and properly dispose. Erie to furnish and install shield where applicable. And install fiberglass dimensional shingle. And install all accessories that may include drip edge, pipe boots, roof properly. And install Premium Synthetic Underlayment. And install decking with OSB where applicable. NOTES fiber roof on entire home. Dumpster in bottom of driveway. Install white drip Shadow.

Install 2 1/2-ton heat pump, 1 innovair 2 1/2-ton air handler, install multi zone comfort system, 2 1 1/2-ton heat pump system outside units and 4 controlled wall mounted inside units.

Replace existing gas furnaces pm 1st and second floor.

Install 2 8.5-ton roof top units - 2 standard curb and 2 economizers, install 1 4-ton rooftop unit and 1 standard curb, no penetration on roof.

For finished attic, install gas furnace, 1 2-ton 13 seer AC unit, 1st and second floor - install 1 gas furnace and 1 3-ton AC unit, install 1-ton heat pump system in basement and connect to wall mounted 9000 BTU and wall mounted 12000 BTU, vent laundry and bathrooms.

HVAC

Install 1 2-ton heat pump system with 2 heads, 1 9 L head for bedroom and 1 12 k head for main room.

Linesets.

Mechanical- 1st and second floor install 1 gas furnace and 1 2 1/2-ton AC unit, no gas piping or electrical.

AC unit, 13 SEER, 410A. No electrical or gas piping.

First floor install: 2 3-ton heat pump systems, 2 daikin wall mounted units 7000K, 4 daikin wall mounted units 9000K, 2 daikin wall mounted units - 12,000 K, vent 2 bathrooms.

1 apts - each 1: 1 multi zone comfort, 1 outdoor unit connected to 4 separate inside units individually controlled by 1 outdoor unit, install: 1 daikin heat pump system, 1 daikin wall mounted unit for bathroom 7000 BTU, 1 wall mounted unit for main area 18000 BTU, 2 daikin wall mounted unit for bedrooms 900 BTU,.

2 units, unit 1 - install high efficiency gas furnace and 1 Rheem 2-ton AC, Unit 2 Install high efficiency gas furnace BTU and 1 2-ton AC - vent bathrooms and laundry, No electrical or gas piping.

First floor install - 1 high efficiency gas furnace, second floor install - 1 high efficiency gas furnace, install new duct work for furnaces and install gas piping for furnaces.

HVAC Work

Disconnect and remove the old inside unit and outside unit; install (1) Trane 2 1/2 ton AC unit, 410 A, 13 SEER, and 1 Trane 60k BTU, 92% gas furnace.

For a new second-floor addition: install a gas furnace and 2-ton AC unit.

16000 first floor- second floor- 410A. No Electrical Install: 1- Goodman 95% Gas Furnace 60,000 BTU and 1- Goodman 2-ton AC Unit 1. 3 Seer 410A. ANTONIOS Install: 1- Goodman 95% Gas Furnace 60,000 BTU and 1- Goodman 2-ton AC Unit 1. 3 Seer or Gas Piping.

Install 3 1/2-ton hydro unit and 3 1/2-ton AC unit.

Install gas furnace and 2 1/2-ton AC unit on first floor, second floor - gas furnace and 3-ton AC unit.

Install gas furnace and 2 1/2-ton AC unit on first floor, gas furnace and 3-ton AC unit on second floor.

Install gas furnace and 2 1/2-ton AC unit on first floor, gas furnace and 3-ton AC unit on second floor.

Move the equipment hood to the left 10–12 inches and extend the vent pipe.

Install a gas furnace and 2 1/2 ton AC unit on the first floor, and a gas furnace and 3 ton AC unit on the second floor. No gas piping or electrical work.

HVAC Work

HVAC Work

Upgrade the oil furnace and install new flexes, a new supply, and new ductwork.

Installation of a gas furnace, a 2 1/2 ton AC unit, and a 3 ton AC unit.

Installation of a gas furnace, 2 1/2 ton AC unit, and 3 ton AC unit.

Install 1 gas furnace, air temp 2-ton AC unit, second floor - install gas furnace and (I1) 3-ton AC unit - no electrical or gas piping.

Install a gas furnace with a 3-ton AC unit.

Upgrade from oil to gas, install a gas furnace and replace the 2 1/2 ton AC unit, and run a gas pipe.

First floor - Install gas furnace and 1 2 1/2-ton AC unit, second floor - install 1 gas furnace and 2-ton AC unit.

Install (1) 2-ton AC unit — Unit A.

Finish area on top of garage—install (1) Bosch 2 ton SEER ductless heat pump and (1) Bosch inside unit, 20 SEER.

2 family - Units 1 and 2 - Install gas furnace and 1 3-ton unit.

Install a high-efficiency gas furnace and 3-ton AC unit. No electrical or gas lines.

Install gas furnace, 2 1/2-ton AC unit on first floor and a gas furnace and 3-ton AC unit on second.

1 1/2-ton AC, gas furnace, and 2-ton AC with 2-ton heat pump/electric heat and (1) 2-ton air.

Install First floor: 1 gas furnace, 1 AC unit; second floor- 1 gas furnace, 1 AC unit; third floor - 1 heat pump and electrical heat; 1 2-ton air handler.

First floor: Install gas furnace and 2 1/2 ton AC unit on second floor and finished attic; install 1 Rheem 95 high-efficiency gas furnace, variable speed, and 1 3 ton AC unit; vent kitchen, bathroom, and laundry.

HVAC Work

HVAC Work

HVAC Work

Installation of gas furnaces and a 2 1/2-ton AC unit.

Installation of gas furnaces and a 2 1/2 ton AC unit.

First floor: Install high efficiency gas furnace and 2 1/2-ton AC unit, second floor: Install gas furnace and 3-ton AC unit.

Install 2 furnaces and 2 2-ton coils, and run a gas line for the water heater and boiler.

2 gas furnaces with A for entire house with 6 zones - direct vent.

Install a gas furnace, a 2 1/2 ton AC unit, and a 3 ton AC unit.

Install 2 gas furnaces, 1 AC unit, and 1 3-ton AC unit. Outside work is pending zoning.

Install 2 gas furnaces, 1 AC unit, and 1 3-ton AC unit. Outside work pending zoning.

Install 2 gas furnaces, 1 AC unit, and 1 3-ton AC unit. Outside work pending zoning.

Upgrade 2 furnaces with 2 goodman 60,000 BTU and relocate some supplies and returns.

Replace existing units with a 2 1/2-ton air handler and a 1 2 1/2-ton heat pump.

High efficiency BTU and 3 1/2-ton AC unit.

Disconnect two existing hydro units and AC units for renovation work to be completed and then reconnect units to first floor and install 1 first company 3-ton hydro unit and 1 carrier 3-ton unit.

Install a 6-zone heating and cooling system with a high-efficiency gas furnace.

Install (1) air handler in attic and 1 Goodman 3 ton AC unit.

Install 1 3-ton hydro unit - no electrical or water lines.

Extend ductwork and relocate supplies and returns.

Upgrade 2 inside hydro units: 1 - 2-ton hydro unit and 1 4-ton hydro unit.

First floor: install gas furnace; second floor - Install gas furnace and 2-ton AC unit.

Remove (2) existing furnaces and install 1 gas furnace; insulate assorted ductwork to code and install (2) hydro-air blowers; E20-1005-Ele No Fee: miscellaneous electrical for remodel.

Raising existing ductwork and flexes for a cathedral ceiling.

Mechanical: Relocate existing supplies and relocate and extend supplies for the first floor.

Adding/updating hvac.

Install first floor.: 2 zones; 1) first floor. Zone 2) finished basement; 3-ton 13 seer 410A freon air conditioning unit; Second floor: 1 gas furnace (40000 btu), 1 1 1/2-ton 13 seer Freon air conditioning unit; no electrical. Nor gas-piping.

Mechanical- replace 3-ton gas furnace - no electrical, no gas piping.

Mechanical: install gas fittings.

Mechanical: Remove and install a gas furnace and AC unit.

Mechanical work: boiler and AC.

Mechanical: upgrade units.

Mechanical ductwork for kitchen renovations.

Mechanical: Upgrade air conditioning only; new ductwork for second-floor cooling only.

Mechanical work: AC units, hydro units, and ductwork. No electrical or gas piping.

Mechanical - extend 3 exist. supply's.

Mechanical: Replace the existing heat pump and AC units. No electrical or gas pipe.

Mechanical: relocate 7 supplies.

Mechanical: Change electric heat to a gas furnace and pressure test.

Mechanical: relocate existing supplies and returns.

Mechanical — relocate existing supplies and returns.

Mechanical: 2 furnaces, 2 AC units, and duct work.

Mechanical: Run 10' gas pipe for gas stove.