Cale M Tuite

Electrical Work

Gallon AG LP tanks and run 35' 3/4" copper line from tanks to generator.

Install Generac Remove the rotted or damaged 14kw generator with 200-amp ATS and load sheds back half roofing to the roof decking. Install new sheathing where as needed. Install a new asphalt shingle roofing system. 8.

Condenser.

Install GFCI This work is Knollcrest Drive. Construction breaker in panel. In addition to the foundation permit (RB-26-23) that was issued for 11 The work proposed for this stage is to be the remaining of the physical residence which will be 2 bedrooms, 2.5 bathrooms, 2.

Provide wiring for a new air conditioning condenser, air handler, and service outlets.

Electrical Work

Provide wiring Installation basement for a Replacement air conditioning condenser, and service outlet of 3/4" schedule 40 gas piping from already supplied branh in on Natural gas main to a generator. Gas meter has been verified to be.

Condenser.

Provide wiring This is a renovation demolitioned, installed and for: 1- Mini-split condenser and service outlet of an older pine deck on a sleeper frame. Deck to be new EPDM roof overlayed on the garage, new sleeper frame composite decking/composite rails with new landing and stairs. Same.

Provide wiring Oil to liquid propane gas for 1-Mini-split condenser and service outlet conversion. Install new liquid propane gas furnace, run new PVC venting and.

Install (14 kW) generator with 200-amp ats @ single-family residence.

200-amp oh upgrade and new central air system wiring: AC, ah service outlets (mech by tyler air).

Heating and Air).

Outdoor condenser. Construction utilizing part foundation remodel, which of a new single family home. It will be roughly 2951 SF, 2.5 stories, of the existing foundation, with the remainder built on the new that was poured in June 2025 for the planned home addition and ended up in a full demolition of the existing home on the property.

Provide wiring for 1-new mini-split AC condenser and service outlet.

Install 26kw Remove existing Generac generator with 200amp ATS and load sheds shingles and apply 17 sqs of new GAF Timberline HDZ asphalt.

Outlet for tankless water heater (HVAC by Tyler Heating & Air).

Electrical wiring for a new 26 kW Generac generator with a 200 amp ATS and load sheds.

Install GFCI Install a new the pool the concrete and one 10' breaker in panel. Install service outlet within 25' of outdoor condenser. Black Ornamental aluminum 48" High two rail fence around perimeter approximately 278 linear feet all post will be 2-by-2-foot set into footings with ball caps, also installing one 4 ' wide single swing gate Doble Drive Gate and gates posts will be 4-by-4-foot set into the concert.

Installation of a GFCI outlet near the condenser location.

Required GFCI Take down existing brick. No alterations breaker in panel. Exterior brick chimney, rebuild to existing specifications using new being made to existing smoke chamber and hearth only exterior.

Install code required GFI breaker in panel for outdoor condenser.

AC unit - provide disconnect and service outlet for replacement air conditioning condenser (HVAC by Tyler Heating and Air).

Breaker in panel. Remove old furnace air conditioning coil and condenser. Install new furnace air conditioning coil and.

Wiring for new air conditioning, compressor and air handler - install service outlets.

Replace the 200-amp MB panel with a new panel.

200amp panel Installation of will remain. Update grounding an UL-300 approved wet chemical fire suppression system for the kitchen hood.

Wiring for replacement heat pump air handler with electric heat strip and service outlet.

Install 22kw standby Install 22kw standby generator and ATS. To be powered by liquid propane generator and ATS, to be powered by LP (Also installing gas lines and 2x.

Wiring for a mini-split and one GFCI outdoor service outlet.

Provide wiring, disconnect, and service outlets for (1) AC compressor and (1) air handler.

Provide wiring for: 1-AC condesner and 1-Air Hander (HVAC by Innovative).

Install a GFCI breaker to replace the existing breaker for the air conditioning replacement. Air conditioning system with a new American Standard 4A7A4048 4 ton 14 Seer condenser.

Install 24kW Generac generator with 200-amp ATS and Load Sheds.

Wire a new heat pump water heater.

Wiring for AC installation: 14 SEER, 3-ton condenser with AC “A” coil.

Wiring for 1 ductless condenser.

2688 Wiring for new 18kw standby generator, includes ATS.

Wire 1 air conditioning condenser, 1 air handler/furnace, 2 electric baseboard heaters in basement.

Electrical wiring for (1) AC condenser and (1) air handler.

Wiring for new AC install.

Install 22 kW generator with 200-amp ATS.

Electrical Work

Electrical Work

Wiring for a new AC condenser.

Electrical Work

Electrical Work

Install 14kw Honeywell generator on left side of house (to be powered by propane 2 120 gallon A/G tanks). only for generator not for tanks*.

Install a 10 kW generator with a 16-circuit ATS panel.

22 kW generac with 200 ATS 1 of 2 - 200-amp panels on generator.

Wire an 18 kW generator with a 200 amp ATS.

Install a 22 kW Honeywell generator. Run a 3/4 plastic gas line in a trench 20 feet to the new generator. The 500 U/G tank is pre-existing.

Electrical wiring for new air conditioning.

Wiring for 22 kW generator with transfer switch; H20-0459-Mech No Fee: swap existing 60 gallon w 120 gallon above ground tank add 2 additional 120 gallon above ground tank for generator.

Electrical: wire a 20 kW generator and 200 amp ATS.

Electrical: 200 amp service upgrade.

Electrical: 200 amp service upgrade.

Electrical - wire 1 AC condensor.

Electrical - 200-amp service upgrade - HVAC wiring for 2 ductless condensers.