Local provider profile
Documented work across Connecticut based on attributed municipal records.
Work history
Individual records are grouped by address. Totals include only values reported in public records and may not equal final construction cost.
Disconnect and remove the existing Murray 200 amp panel. Supply and install a new Square-D QO series 200 amp, 42-circuit main lug panel. Supply and install new Square-D QO breakers and label the panel. Existing grounding in the existing 200 amp Kohler automatic transfer switch, supplied by others, will remain.
$4KRough wire and finish electrical for kitchen, breakfast area and pantry renovation.
$13.5KRough wire and finish electrical in kitchen, breakfast area, dining room, laundry and powder room.
Supply and install (1) Generac 26KW standby generator and (1) Generac 200 amp automatic transfer switch. Rework and install new grounding as needed. Supply and install ground bars in the existing main panel, and isolate all grounds and neutrals to meet code. The distance from the house to the generator is approximately 100 feet.
$17.5KSupply and install (1) Generac 26KW standby generator and (1) Generac 200 amp automatic transfer switch. Rework and install new grounding as needed. Supply and install ground bars in the existing main panel, and isolate all grounds and neutrals to meet code. The distance from the house to the generator is approximately 100 feet.
$17.5KRough wire and finish electrical for kitchen/dining room and powder room renovation.
Disconnect and remove the existing 100 amp overhead service. Supply and install a new 200 amp service with new grounding to meet code compliance. Supply and install a Square D HomeLine UL-listed interlock kit.
$4KDisconnect and remove the existing 100 amp overhead service. Supply and install a new 200 amp service with new grounding to meet code compliance. Supply and install a Square D HomeLine UL-listed interlock kit.
$4KRough wire and finish basement renovation including wet bar, kitchennette, full bath with washer and dryer.
Supply and install (1) Generac 10 kW automatic standby generator. Supply and install (1) Generac non-service-rated 100 amp automatic disconnect switch. Supply and install (1) 20-circuit Square D Homeline subpanel for new generator circuits.
$10KRough wiring and finish two second-floor baths, kitchen renovation, and partial sunroom/master bedroom addition.
$30KRemodel 3 bathrooms and upgrade electrical in the kitchen and family room. 20 switches, 12 outlets, and 26 light fixtures (58 total devices). Existing 200-amp service and 1 existing meter.
Electrical - disconnect and remove exist. 100 a mp service and install new 200-amp service interlock kit with portable generator inlet located exterior.
$3K20 devices installed; 3 20-amp, 120-volt dedicated circuits for new GFI outlets and 1 15-amp, 120-volt circuit for new lighting; supply and install recessed lighting and FanTech 190 CFM exhaust fans (remote in attic); install new fixtures.