Hector L Sanchez

All new ductwork for 2 zone system.

HVAC Work

Intake to the outside of the house.

New furnace.

New supply Replace oil electric heat basement connecting the new heater be installed electrical vacuum relief instructions and return ductwork. Boiler domestic hot water system with a GE PH65S10BPY01 65-gallon pump water heater. Install new 1-inch PEX main cold water line in (about 50 ft) from city supply, with 3/4-inch PEX branches to fixtures, to existing 1/2-inch copper pipes for house distribution. Hot water from ties into existing 1/2-inch copper hot water line. Shutoff valves will to isolate the old boiler plumbing. A new 240V, 30A circuit with 10/2 cable will be run for the water heater. Thermal expansion tank and valve (if required) included. All installation will follow manufacturer and local code requirements. No heating system piping changes; oil.

Install new Elder 2 to 3 ton heat pump condenser in discussed location, and install condensate pumps for the heat pump. Evacuate the system to 500 microns and charge it with 410 A refrigerant.

Installation of a new ADP coil on the existing furnace with a filter dryer. GE outdoor condenser on a new poly condenser pad. A 30 amp circuit will be installed from the main panel to the outdoor unit by a licensed third-party electrician for new AC.

Install new burnhan alta -200 c combi boiler 2 zone.

Install furnace, Ideal combi boiler, and tankless water heater.

Navien combi Safety Center LLC Tenant Fitout for garage repair boiler to feed the air handlers and produce hot water.

Install a new 60k As a provision BTU Goodman furnace, gas fired with a 1.5-ton cased coil for AC. For the future we would like to run 2 conduits from home to rear of property for.

Adding baseboard to the existing boiler for 2 bedrooms, 1 bathroom, and a family room.

The unit is installed. We will start it up and set it to specifications for optimal energy savings.

Installation of 2 baseboard heaters for 2 bedrooms.

Installation of 4 baseboard heaters and piping for basement bonus room.

HVAC Work

Remove gas boiler/installed high efficiency gas furnace with all the ductwork -*. no outside work.

Installment of duct system to provide heating and cooling. 90 efficient gas fired furnace.

Mechanical replacement and maintenance of existing hydro loops.

Mechanical: Install central AC on the main level. Air handler located in the attic.

Mechanical: Install a furnace in the attic with a cooling coil and drainage.

Mechanical: Install a gas line to the furnace.

Mechanical — install a furnace with AC and a gas line to the range, water heater, and furnace.

Mechanical: Install a new LP gas piping line to the range, water heater, and furnace.

Mechanical: Install an LP gas furnace with an air conditioning coil.

Plumbing for the first-floor bathroom and kitchen, and new plumbing to the second-floor bathroom.

Mechanical: replace boiler and water heater.

Mechanical: Pressurize existing gas lines to the stove and dryer.