John M Rienzo

Run electrical in a dermatology suite and cabinets; wire a new mini-split to code and install a 120 plug within 25 ft. of the unit.

200-Amp transfer switch.

Install new outdoor Replace new kitchen Bath first floor WR GFCI within 25' of unit cabinets same location. Hall bath replace toilet and vanity, new tile floor. Same location new tub, toilet, and vanity. @nd floor bath new shower/vanities.

Wire a new above-ground pool to code.

Install 22 kW generator and 2 LP tanks at side of single-family residence.

Install 22 kW generator with 100 amp transfer switch.

Wire new ductless Remove the all joins of the Roofing Underlayment minisplit to code. Install WR-GFCI WITHIN 25 FT. OF UNIT existing roof and tear off all additional layers. Install the roof deck tape in the plywood. Install six feet of leak barrier (ice and water shield). Install Synthetic over the entire roof area. Then install the new Asphalt Architectural.

Reattached. Bring temporary power back to house.

Install a new 16 kW propane-fueled generator at the back center of the house, approximately 5 ft. Off the house. Install a new 200-amp transfer switch in the garage next to the panel.

Wire air handler and condensing unit for air conditioning.

Install a new 22 kW generator on the left front of the house and a 200 amp transfer switch on the left side of the house.

Install 22 kW generator and 200 amp ATS at the left front of the single-family residence and (2) LP tanks at the rear. E22-0524-Ele No Fee: Install new 22 kW generator located on the left front of the house; install 200 amp transfer switch on the left side of the house.

Install a new 24 kW Generac generator on the right rear side of the house and a new 200-amp transfer switch in the basement. Propane will be the fuel source. Noted 10/14/21 {MK}.

Electrical: Run new circuits to the existing kitchen for countertop plugs, a refrigerator plug, and a DW circuit. Install (6) recessed lights.