Kyle D Wheeler

HVAC, Geothermal, Chimney liners & Oil Tank Permit WILTON

HVAC Work

HVAC Work

HVAC, Geothermal, Chimney liners & Oil Tank Permit WILTON

HVAC Work

HVAC, Geothermal, Chimney liners & Oil Tank Permit WILTON

HVAC Work

Adapt existing ductwork to accommodate the new office layout.

HVAC Work

Install a new propane-fired boiler and water heater, with new propane lines. Propane water heater with a new propane line to the boiler and water.

Heater.

Install 2 new forced air systems, gas furnaces with AC, new ducts and outdoor condensers, on demand water heater, venting.

Install a ducted heat pump/AC for the second floor with new ducts and an outdoor condenser. Install a ductless wall-mount split for the family room with an outdoor condenser.

Mechanical: Replace the existing oil furnace and AC with a new propane furnace and AC. Mechanicals back in the same location.

HVAC

HVAC

Install ductwork only for new geothermal equipment, bathroom, and dry venting.

Install a new gas-fired furnace and 5 TON system with a new outdoor condenser. All existing ductwork to remain.

Install (2) new gas furnace systems with air conditioning and new ductwork, with kitchen and bathroom venting.

Remove existing Run gas line from oil fired furnace and install new gas fired furnace with central AC- new gas meter to inside of house and connect gas furnace, install on.

Adapt existing ductwork.

Install a new central air system with new ducts.

HVAC

Replace the boiler and install a new gas line to the boiler.

Replace the existing gas line from the meter to the boiler and water heater.

Relocate 2 return ducts; install a new kitchen hood vent, fresh air intake, and 2 dryer vents.

Install 2 new air handlers and heat pump condensers with new ductwork - first floor - 12,0000 BNRU and second floor - 18,0000 BTU.

Install 2 40000 BTU gas furnaces 2 2-ton AC coils and 2 @ ton condensers with new duct work for the first and second floor Instal 18000 ductless split.

HVAC Work

Install new ducts off the existing system to accommodate the new layout; convert to hydro heat off the existing boiler.

Install 3-ton min i split condenser on left side of single-family residence, 12000 BTU wall mount air handler for living room and I1 9000 BTU for first floor bedroom and 1 ducted air handler for second floor.

HVAC Work

HVAC

Install a new air handler and condenser for the third floor.

Install a new high-efficiency propane boiler and (3) hydro heat and AC systems (no outside work; pending zoning).

Install a gas furnace, a new 2 1/2 ton AC coil and condenser, and a new 40 gallon gas direct vent water heater. Run new gas pipe from the meter to new indoor fixtures.

Ductwork only - modified one supply duct into 2 smaller ducts to accommodate new ceiling layout.

Install new LG VRF single- and multi-zone systems; 191 outdoor units and 24 indoor wall-hung units; sized and installed according to plans.

Mechanical: Install 2-ton outdoor AC condenser.

Mechanical: (3) new hydro heat and AC systems and new oil-fired boiler.

Mechanical - replace exist. AC system, air handler, gas furnace and install 50 gallon LP direct vent water heater (gas by others).

Mechanical - install furnace and central AC for 2nd and 3rd floors additions, install new 2 zone duct system and split for first floor addition.

Mechanical - install 2 air handlers with hydro coils, connect to exist. boiler, install new duct work and 2 new condensors.

Mechanical - convert 2 oil furnaces and water heater to natural gas, 2 new AC coil and condensers, 50 gallon direct vent and new gas service.

Mechanical: Install direct-vent furnaces, air-conditioning coils and condensers for each separate unit (7 units total; 8 furnaces and 8 condensers), and new ductwork for each unit.

Electrical: Install a new outlet and replace the existing panel.

Mechanical - Install new furnace, condenser, 40gal HW heater - run new gas lines and install ductwork.