Panagiotis Koumasidis

Install ductwork, a register, zone dampers, and a gas line. Labor to pipe 1 Navien 240 combi boiler, run water lines, connect the existing air handler to ducts and heating water lines, vent the boiler, pressure test gas lines, and rough in refrigeration lines for future use. Condenser not included.

Install owner's three-zone ductless system. Refrigeration lines; start system.

Replace the oil-fired boiler with a propane combi boiler, run a gas line to the stove and boiler, and pressure-test.

Install 2 gas furnaces with AC coils, 2 condensers, second floor, 1 zone ductwork and registers with r8 insulation, first floor, 2 zone ductwork, venting of furnaces, refrigeration lines, install, 2 condensers, run gas lines and pressure test, and install two new gas water heaters.

Install an outlet in the closet.

Replace the existing oil-fired boiler with a propane direct-vent boiler. Run a gas line and pressure-test it. Replace 2 existing hydro air handlers.

Replace smoke damaged ductwork and furnaces - AC coils first and second floor, vent bath and kitchen hoods, replace water heater, connect gas lines, vent flue pipe PVC.

Install a gas-fired, direct-vented gas furnace with an air conditioning coil, ductwork, thermostat, registers, refrigeration and drain lines, and a condenser at the approved location.

Install (2) heat pumps and air handlers; replace all ductwork; vent the bath and dryer; and install new refrigeration lines.

Repair and replace ductwork as needed.

Install 2 gas furnaces with AC, vent units, ductwork and refrigerant lines.

Install 9 ductless heat pumps for classrooms, install bathroom exhaust ducting, sewer hydro split system with AC, two hydro system for existing building, ductwork, refrigeration, line drain, snake sensors in ductwork, registers - grills, etc.

Renovate existing ductwork and make system 3 zones, air handler and condenser to remain, replace coil fired boiler with gas boiler vent system.

Install boiler and water heater cascade system, replace existing oil unit, run water lines to existing hydro unit, run gas line to propane tank location; P22-0026-plumbing No Fee: Disconnect existing oil fired boiler, install new kitchen and appliances, existing power room sink and toilet reset.

Install 2 gas furnaces, ductwork, condensers, and refrigerator lines; vent both the dryer and kitchen hood.

Install 45 feet of gas pipe, a new furnace, and ductwork. No air conditioning at this time.

Mechanical: Install a new boiler and circulators, connect to existing water lines, run a new gas line, and pressure-test.

Replace the oil furnace with a gas furnace. The gas line is existing at the furnace location. Connect to the furnace.

Mechanical: Convert from oil to gas, install a new gas line and pressure test, and install a new gas boiler/water heater.

Mechanical: Install 3 AC units and equipment.

Mechanical: Replace 2 ductless heat pumps.

Mechanical: residential air-conditioning installation.

Mechanical: Install gas line and pressure test, add NW coil to existing air handler, and install boiler.

Mechanical: replace furnace and water heater, and install AC.

Mechanical: Install ductwork, refrigeration lines, drain lines, bath and kitchen hood vents, and air handlers.

Mechanical work: gas lines to stove, furnace, and water heater; replace heat pump and air handler; install gas furnace, condenser, and AC coil; vent kitchen hood.

Mechanical: Gas lines to stove, furnace, and hot water heater; replace heat pump and air handler; install furnace, condenser, AC coil, and vent kit hood.

Mechanical work: 3 hydro air handlers, ductwork, vents, kitchen and bath, and water heater.

Mechanical: Install an air handler and a new boiler. Run a new gas line.