Local provider profile
Documented work across Connecticut based on attributed municipal records.
Work history
Individual records are grouped by address. Totals include only values reported in public records and may not equal final construction cost.
AT and T will install 9 new antennas on the building’s rooftop, where other carriers’ wireless facilities are located. The antennas and associated equipment will be installed on 3 non-penetrating ballast frames mounted on the existing rooftop. Unmanned supporting equipment will be located in an approximately 220 SF equipment room in the building’s basement.
$361KAT and T proposes direct air cooling upgrades to its existing telecommunications facility including the installation of one 1 new dual-fan direct air cooling (DAC) unit on new plenum installed through AT and T chimney hut ceiling, the installation of a 2' x 2' x 1'-8" dog house on rooftop of AT and T chimney hut and make opening into RRU space below, the installation of five 5 new exhaust vents in new AT and T dog house, the installation of two 2 new exhaust vents in AT and T chimney hut wall.
$10KBuilding
$180KAT and T Wireless to swap out 3 antennas, swap 3 RRUs, and add 3 RRUs on the existing water tank. Ancillary equipment changes within the existing shelter.
$90KAT and T Wireless: Remove 6 diplexers, 3 tower-mounted amplifiers, and 3 remote radio units; add 3 low-band converters and 3 SBTs. An SBT is a small component attached to the antenna below it to make the Remote Electronic Tilt (RET) motors work. Replace the 3 existing RRUs located within the shelter with 3 newer model RRUs. Add various new equipment inside the shelter.
$30KModify the existing AT and T antenna facility on the town-owned tower. Remove 9 antennas and install 6; remove 3 remote radio units (RRU) and install 9; remove 6 coax and install 2 DC, 1 fiber, and 1 surge unit. State education fee: $11.70.
$45KReplace existing AT&T antennas at the top of the existing cell tower — 6 total.
$70KReplace 3 existing antennas for AT&T.
$95K