Richard A Pucci

HVAC Work

HVAC Work

Supply vents and 1 large return duct.

HVAC Work

Replace the air conditioning condenser in the back of the yard next to the Bilco doors, and replace the coil.

Trane cased Remove and air conditioning coil (model 5TXCC009AS3HCA) in basement. Replace 12 windows and 1 sliding glass door, like for like with no.

Replace existing Remove and condenser, boiler with 1 Burnham PV8H3WECTBWN oil fired boiler dispose of existing air conditioning equipment. Install new Trane 3-ton model 5ttr4036, on condenser pad at right side of house. Install new.

To pool heater + 16' 5/8" copper line from tanks to grill.

HVAC Work

Install (1) 120-gallon propane tank at the rear of the cottage and connect to the sub out for hot water and cooking.

Replace the existing oil tank and furnace in the basement with (1) Roth 275-gallon oil tank and Spirit VHF-ACP oil-fired furnace in the same location.

HVAC Work

Replace existing Replacement boiler in first floor room with Weil McLain CGA-5 gas fired boiler. Of existing hot water heater with AO Smith gas water heater in same.

Location.

HVAC Work

Run 40' of 3/4" black pipe from the existing propane tank to the new generator.

HVAC Work

In same location.

Replace the existing air conditioning with a new 2.5 ton Trane condenser on a pad in the back of the house, matched with a new Trane air handler in the attic.

Replacement of the existing furnace in the basement with a high-boy Spirit oil furnace.

Run 75' of 1/2 copper gas line from the existing tank to the new fireplace.

Replace water Install Miscellaneous Frames, Doors and heater with Indirect Burnham hot water heater AL55LT.

Wiring new HVAC equipment for Air Incorporated. Upgrading service from 100A O.H.

Replace the boiler with a Burnham EMP-140 boiler.

Location Furnish and the black card-Demo existing tanning bed for new tanning and tie secondary-Replace all new Exit/EM integrated into-Relocate existing-Demo existing circuitry for 100A sub panel Install 36 new conduit and install 2 new outlets and relocate, 2 existing outlets for massage chairs in area feeds to 6 tanning beds. Furnish and install 1 new 60A feed to new location. Install 7 new 60A disconnects, 6 for existing tanning beds and 1 bed. Install 7 buck boost transformers on walls behind tanning beds from transformer into tanning beds. Exit lights in the facility with new LED exit lights. All egress doors to get lights with new remote egress heads outside. Emergency lighting will be the new ceiling lighting as shown on drawings. Ceiling fan controls to front desk area. Floor outlets for all treadmills, which are against code. Demo existing all treadmills because feeds are undersized. Furnish and install 1 new in existing electrical room next to bathrooms for all treadmill feeds. 20A circuits from new 100A panel to room 101B. Install new EMT floor mounted junction boxes for all treadmills and stair stepper.

Replace oil Disconnect-Cut and cap-Install new-Direct vent-Tie into existing-Install shut-Reconnect-Install new-After installation, tank in basement with new tank in same location and remove existing furnace oil lines (we do not remove the lines) furnace in same location outdoors with 2in pipe (location to be determined) gas line manifold off valve and trac-pipe flexible gas line existing low and high voltage wiring condensation pump (location to be determind) start system and check operation to confirm maximum.

Replace the existing boiler in the basement.

Replace existing power supply for control panel, one GFI boiler in basement with Burnham oil boiler in same location.

Replace the boiler in the basement.

Remove the existing furnace and air conditioning. Replace them with a new ThermoPride furnace and evaporator coil in the basement. Replace the condenser with a new Trane 2.5-ton condenser in the rear of the house.

Replace the existing boiler and indirect water heater on the first floor with a Weil McLain (CG1-4) gas boiler and a Burnham (AL30LT) indirect water heater in the same location.

HVAC Work

Basement. Installation Remove and dispose of existing of existing boiler and indirect. Of a Level 2 EV Charger:Level 2 Battery, 240watts, 48amps-Mercedes.

Water and Install 2-100G stove. Above ground propane tanks and connect to a plumber's stub out for.

Basement, Trane AC Condenser (4TTRL4048L-1000A) outside.

Replace the boiler with a boiler in the basement.

Replace the existing boiler in the basement with a new oil-fired boiler in the same location.

HVAC

Outside of home Install 22KW Generac automatic standby generator. Install 20ft electrical line from generator.

HVAC Work

Install a ductless AC condenser/heat pump at the back of the house and one indoor wall unit in the master bedroom.

Boiler (PV8H3WEC-TBWN) and Vaughn indirect water heater (S-50TPP) in the same location.

Water. Removal of existing dry standpipe system in parking garage and installation of new dry.

Replace boiler in basement: Burnham V8 with Beckett burner.

Alliance indirect New plumbing addition. First water heater (AL55LT), same locations. Install for 1 full bath, kitchen and laundry room. Not original plumber on this plumber was removed from job. I will be doing fixture install to complete job.

HVAC Work

Stove. Remove existing shingles and apply 22 sqs of new GAF Timberline HDZ asphalt shingles along.

HVAC Work

Remove and replace the existing boiler with an oil-fired boiler in the same location.

Replace the existing boiler in the basement with a new oil-fired burner.

Replace boiler in basement: Peerless oil-fired boiler (WBV04-WPCTL) with coil and burner.

To plumber's existing gas line.

Carlin burner and fresh air kit.

Run 30' of 1" corrugated Conversion from stainless steel tubing and connect to plumber's existing gas line. Oil to gas boiler. Install 30' of 1" corrugated stainless steel tubing and connect.

HVAC Work

Install a 24 kW Generac generator with a 200-amp ATS, powered by 4 120-gallon A/G propane tanks.

Remove the existing boiler and install a new oil-fired boiler.

Remove the existing boiler and replace it with an Energy Kinetics boiler.

Run 10-20 feet of 5/8 copper gas line to new grill. Tie in to existing line from house.

Replace the existing boiler in the basement with a new fueled boiler.

Replace the existing boiler in the basement with a new oil-fired boiler.

Set (3) 120 gal AG LP tanks and run gas line to generator.

HVAC Work

Install a 60-gallon AG LP tank and run 20' of 1/2" copper gas line to a new gas range.

Swap out the existing AG LP tank for a 120-gallon AG LP tank and run a gas line for the stove and fireplace.

Install 3 120 gal above-ground LP tanks and run 40' of 3/4 copper gas line to the boiler room for the boiler and hot water heater.

HVAC

Mechanical — install a gas hot-air furnace with cooling and a condensing unit.

Mechanical: propane gas pipe for kitchen stove and fireplace.