Salvatore Colapietro

Replace (1) water source heat pump and exhaust fans. Install new branch duct.

HVAC, Geothermal, Chimney liners & Oil Tank Permit WILTON

HVAC

Install a new mini-split heat pump for a new addition.

HVAC Work

Replacement Electrical work replacement of of a 30A disconnect power, installation associated with the elevator modernization project. Work includes existing lighting with 4' LED fixtures in the elevator machine room, installation for cab light, installation of a 100A shunt trip disconnect for the mainline of additional 20A 120V circuits to the elevator machine room and pit.

Pertaining to Rip and replace rake edge, install installation also installing a gas fired tankless hot water heater and gas piping asphalt roof. Install new ice and water on entire roof. Install new drip edge, new pipe boots. Install new ridge vent with cap shingles. Install new.

Generator.

HVAC Work

Install four heat p0umps system and ductwork pertaining to heating and AC system.

24000Install two gas fired derict vent 95% with AC and all ductwork pertaining to installation of heating and air condittioing system SALVATORE.

Installed two supply runs for one finished room in the basement off the existing system.

Install one mini-split heat pump for the kitchen area.

Install a hydro air system and ductwork pertaining to the second floor, and a new tie-in to the existing boiler.

Install a mini-split heat pump system for the finished room in the attic and a fan-in-a-can for combustion air in the basement mechanical room.

Rework ductwork to accommodate a kitchen renovation. Also install a mini-split heat pump for a new sunroom addition.

HVAC Work

HVAC Work

HVAC Work

Install a new oil-fired furnace, hot water heater, and ductwork for 2 zones with air conditioning.

HVAC

Install a hydro-air system with a propane-fired boiler and air handler, as well as all ductwork pertaining to the system.

Installation of two propane-fired furnaces, an air conditioning system, and all ductwork pertaining to the systems. LPG tanks by others.

Install 2 hydro-air systems and ductwork, tied into the existing gas-fired boiler, and air conditioning.

Run ducting for both fans and relocate supply grilles for bathrooms. Renovation.

Move supply ducts to accommodate renovation.

Mechanical: Install 1 gas-fired furnace and AC, add ductwork, and install a 2-zone direct-vent furnace.

Mechanical: Install new ductwork. Existing furnace and air conditioning to remain.

Mechanical - install gas fire furnace, direct vent with AC, all duct work pertaining to system. Gas pipe done by others. Needs ZA for cond. Location.

Mechanical: Install 2 AC systems; add ductwork and piping. Boiler to be done by others.

Mechanical: Run ductwork for exhaust fans and make-up air, and install a fan in the attic area.

Install makeup air and ductwork to the kitchen hood.

Install a complete heating and air conditioning system; gas-fired direct vent with air conditioning; 2-zone gas pipe done by others; 2 systems.

Mechanical: Disconnect and reinstall the unit for the AC system.

Mechanical: Disconnect the unit and reinstall the condensing unit for the AC system.

Install 4 hydro-air system, all ductwork and piping pertaining to the air conditioning system.

Replace oil-fired boiler with gas-fired boiler; direct vent and run gas pipe.

Install a gas-fired furnace and air conditioning, all ductwork, 2 zone. Direct vent 95% furnace. Site plan in file. BB.

Install 2 gas-fired hot-air furnaces, direct vent, with air conditioning and all ductwork pertaining to heating and air conditioning (gas piping by others).

Install 4 hydro air systems with air conditioning, all ductwork pertaining to the HVAC system, and bathroom venting. Boiler to be done by others.