Wojciech Mazur

HVAC Work

Install kitchen hood ductwork and an air makeup unit on the roof; hood vent unit on the roof.

HVAC Work

HVAC Work Plumbing

Install 2 NG fired furnaces - two 3-ton AC systems and ductwork.

Install BTUH furnace, new ductwork, gas line to furnace.

Install water heater and gas line to water heater and stove.

Direct replacement of the existing AC and heating system. Convert furnaces to LP gas, install a gas line to the furnace, and redo ductwork. No outside work.

HVAC Work

HVAC Work

HVAC Work

Relocate the return ductwork and outlet only; no work on equipment.

Heating and cooling for addition: air handler and ductwork in attic; condenser outside.

HVAC Work

HVAC

2 bedroom units with furnaces coil and condensers outside with complete ductwork.

HVAC Work

HVAC

HVAC

HVAC Work

HVAC Work

HVAC Work

Direct replacement of oil furnace and condensing unit.

HVAC Work

HVAC

HVAC

HVAC

ELE

HVAC

Install two gas furnaces with cooling coils and ducts: one in the basement and one in the attic.

Redo the outlets in the remodeled master bathroom for the existing system. Install a new bathroom vent and fan. No change in the area of the house, heat loss, or heat load.

Install 5 indoor wall-hung ductless vents and two outdoor units.

Mechanical: Install a 4-ton cooling-only air conditioning system in the attic with ductwork.

Replace boiler with a propane boiler, using the same radiators; gas pipe inside the building. Receipt 20-0844.

Install hydro-air heating and air-conditioning systems with ductwork for the first and second floors, and hook up to the existing boiler.

2 gas-fired furnaces with cooling coil and complete ductwork; 1 system on attic and another in basement; condensers by house according to plans. Amendment (1/15/21): new zoned forced air system: heating and cooling, new ductwork; new high eff. Tankless water htr., venting of bathrooms. And laundry, kitchen.

Install 2 furnaces with cooling coils and complete ductwork; install a tankless hot water heater and gas lines to all appliances in the house; install condensing units outside the house.

Install an 18 kBTUH gas furnace and ductwork in the attic; install a 30 kBTUH gas furnace in the basement, replacing the system after fire and smoke damage. Existing condensers outside are reused and were not damaged. Amendment dated 4/21/21: Amendment to the air-conditioning condensing unit location.

Install a split heat pump in the addition over the garage.

Move existing air handlers from the house to the garage with ductwork; install/replace/direct replacement boiler (no outside condenser work involved).

Mechanical: Install AC/gas furnace with ductwork for 2 floors.

Mechanical work: boiler, air handler, and condenser.

Add new ductwork for the basement area and a zone control system. No new HVAC equipment inside or outside; use the existing system. ACCA Manual J.

Install a condensing boiler, 29000 BTU; an air conditioning/heat unit for the first floor; an air conditioning/heat unit for the second floor; and ductwork.

More outlets in the interior remodeled part of the house; install a fresh air inlet; no existing HVAC; install kitchen hood ductwork.

Install baseboard heating system with boiler; install 2 zone air conditioning system ductwork on attic, and in basement 2 x 2-ton air conditioning.

Install a ductless Mitsubishi split system: 3, and two outdoor units for bedrooms and the master bedroom.

Install hydroair hndlrs. And ductwork for fist floor. In basement and second floor. In attic; pipe to existing boiler; radiant floor. Heat in kitchen (floor warming). Amendment (3/29/19): install hydro air hndlrs. In basement and for second floor. Attic; pipe to existing boiler; radiant floor. Heat in kitchen (floor warming).

Mechanical: Install 2-zone heating and cooling system, 2 air handlers, a boiler, and an oil tank.

Install a gas line and convert appliances from LP to NG, only in the main house.

Move air conditioning condenser (too old) according to plans.

Install 2 hydro-air heating and cooling air handlers with complete outdoor condensers, outside (no boiler).

Install 2 zones; heating and cooling 2.5-ton systems with ductwork; condensing furnace, cooling coil located in basement and on the attic.

Mechanical: Install a furnace and air conditioner with ductwork and a hot water heater.

Install 2 hydro air complete systems and boiler and tankless hot water heater.

HVAC system for house lighting up; place condenser on roof according to plans and building permit.

Replace air conditioning system for same size and location; convert heat from oil to liquid propane gas-fired boiler and hydro air air handlers(ductwork stays same).

8 outlets (approximately 8) moved according to remodeled interior walls; no furnace or outside air-conditioning work.

Replace boiler and hot water heater; redo ductwork and baseboard radiators according to remodeling plans.

Install a new gas-fired furnace and new ductwork in the attic (heating and air conditioning); install the air-conditioning unit in the same spot as the existing unit.

Air conditioning condenser; install air conditioning and ductwork.

Install 2 HVAC systems, one in the attic and the second in the basement; furnaces, coils, ductwork, and gas line.

Install a wall-hung heat pump for the garage room.

2 hydro-air air conditioning systems; 1 hot water combination boiler (propane); start heat and air conditioning on already installed equipment (2 air handlers and ductwork). Boiler installed by us.

Relocate 2 air handlers and combo boiler air conditioning units in same place; new ductwork on attic room.

First floor: Replace 1 sink and dishwasher; connect icemaker line.

Install a new air conditioning and heat pump system for the 1st and 2nd floors of the main house.

Remove radiators; install a heating coil to the air conditioning unit or an attic pipe coil to the boiler; modify ductwork and add an outlet to the addition rooms. No condensing unit relocation (no outside work).

Install additional furnace unit on attic for second floor. Rooms condensing unit installed by existing unit, replace furnace for first floor.

Install a wall-hung dual-function N. G. boiler for AG/heat for the first floor in the crawlspace, and air conditioning/heat for the second floor in the attic. No gas line or electrical work.

Install a new system for the first floor and only new duckwork for the second floor. Mini-split system for the room over the garage.

Install hydro-air heat and cool air handlers, one on the first floor and one on the second floor; install a dual propane gas-fired boiler for heat and hot water, and a condenser outside.

Install 2 air handlers with complete ductwork for heating and cooling; remove all radiators; connect the air hndlrs. To the existing hot water boiler.

Install natural gas-fired furnace with cooling coil and ductwork.